What exactly is new construction plumbing? It differs from older homes in that the plumbing of a new construction house isn’t normally complete and checked for problems until it is nearly completed. As a result, there is often more risk of plumbing issues that can be potentially serious. Plumbing companies that do new construction projects will need to follow specific codes and hire licensed Plumbing Grand Rapids MI.

In case you’re planning on constructing a new house either as an apartment or rental, there’s a lot you have to think about. You need to hire a licensed plumber, draw up plans, check everything is up to Code, and ensure everything is installed correctly. In addition to laying the groundwork for the new construction itself, these things will also need to be figured into the plumbing system you are installing.

new construction


When you are installing plumbing fixtures in new construction, you need to figure out what kinds of plumbing fixtures you’ll need. For instance, will you have a main sewer line or will you have a private septic? Both require different kinds of plumbing. Main sewer lines are required by most municipal codes, while private septic systems don’t need any municipal regulations. Also, drains will probably need to be installed, as do fixtures like toilet tanks and kitchen sinks.

Another thing to consider when installing plumbing fixtures in new construction is safety. New construction plumbing is usually below the grade of the surrounding ground, so there may be no way for you to see around the area you are working. Be sure to use slip-resistant shoes when working on above ground plumbing fixtures. If you do not have slip-resistantresistant shoes, you should use non-slip paint or other anti-slip products to provide additional protection.

In many new home designs, pipes are installed in what is called the open system. With this type of plumbing system, the pipes come in direct contact with the soil beneath the house. Unless you are accustomed to digging, you should not attempt to install the pipes in this fashion. The reason why pipes come in contact with the soil is because soil expands due to temperature changes and some types of chemicals. Any variation in temperature can cause pipes to expand or contract, causing damage to both the pipe and the surrounding area.

When installing pipes in an older home, there are two main options. You can either install the pipes through holes that have been cut in the ground, or through a trench. If your plumbing is coming in through a hole cut into the ground, there are several considerations you should make before you begin digging. First of all, you should make sure there are no underground gas or oil leaks that could affect the location you are excavating. You may also want to consider how the plumbing is going to be connected to vents and other features, such as vents leading to a laundry room or a kitchen sink.

When digging through a foundation, if you choose to go through the holes manually, it is important to make sure you don’t locate the supply lines for your sewer, natural gas, or water lines. You can often find copper pipes underground that are attached to the walls. These are good choices because they are usually plumb fit, but they are also harder to locate than supply lines. If you suspect you might locate these supply lines, dig a few feet down and see if you can’t find them.

One of the most popular choices for new construction homes is a water heater. In fact, I recommend installing a water heater over an electrical heating system because of the reduced cost and the reduced energy required. However, I do recommend installing a water heater over a natural gas or propane heat source because of the increased risk of electrocution. Electrical heaters are also more expensive to run than natural gas or propane heaters, but they are more efficient and produce less pollution.